Errata in ISO 7235
This is the entry of the errata registry on ISO 7235:2003. The registry’s introduction says how each claim is checked against the printed page and what the status of an entry means.
ISO 7235:2003, Table 6 (the 160 Hz band belongs to no row)
Section titled “ISO 7235:2003, Table 6 (the 160 Hz band belongs to no row)”- Location: Clause 6.2.1, Table 6, “Maximum level differences for three microphone positions in the test duct”, on printed folio 23 (PDF page 33) of BS EN ISO 7235:2009.
- The print: the frequency column reads 50, 63, 80, 100, 125 and then "", with 10, 10, 8, 8, 7 and 6 dB beside them. The header of that column is “Frequency / Hz”.
- The problem: the last row is strictly greater than 160, so the 160 Hz one-third octave is covered by no row and the table sets it no limit at all. Every other row names a single band centre, and 160 Hz is a one-third-octave centre of the same series, so the gap is between the rows rather than in the frequencies the clause measures over: 6.1 measures every one-third octave from 50 Hz to 10 kHz, 160 Hz included. The intended reading is “160 and above” or "", which is also the only reading under which the six rows partition the range.
- Consequence: the rule the table serves is the one that sends a test duct from three microphone positions to five (6.2.1). Read literally, a laboratory measuring the 160 Hz band has no criterion to apply and could keep three positions whatever the spread between them. Read as intended, the limit there is 6 dB.
- Evidence: the six rows as printed, read on the page. Verified on PDF page 33 (printed p. 23) of BS EN ISO 7235:2009, which endorses ISO 7235:2003 without modification: the last cell of the frequency column carries the strict inequality sign and no equals bar, and the five rows above it carry bare numbers.
- Library behaviour:
microphone_spread_limitreturns 6 dB from 160 Hz upwards, and the conformance row “Microphone position spread limits (Table 6)” records the last row as “160 Hz and above”. A test named for the gap pins the value at 160 Hz itself. - Status: unreported.
Created and maintained by José Manuel Requena PlensORCIDAbout the maintainerRelease notesChangelogAll projects